Advertisement
Custom
Panel
Dimensions
36 " Bottom
Mount
Refrigerators
SideView
--
243/4"--
--263/4"
FrontView
103/4"Max
--35"Case
10"Min
•
36"Overall'_
26"
841/2"Max
84 1/2" max
83 1t2" min
Finished
Opening
*Finished Width_
"7
Locate Grounded
Electrical outlet
Within Solid
Area Above
Locate Water
Supply
Within
the Shaded
--
3 112"
Wall View
(not to Scale)
74" From
Floor to
Bottom of
Electrical Area
-3 1/2"
* 36" Min. for a flush installation
into an enclosure.
35-1/2" Min. for a semi-flush
installation
into an enclosure.
Note: Additional
cutout width may be required when side panels are
used. Add side panel thickness
to the finished
cutout width to
calculate
rough-in width. See installation
examples on page 4.
ZIC36N
Bottom
Mount
Refrigerator
Design
Information
Designed to be installed flush or semi-flush
with
surrounding
cabinetry.
Cutout dimensions,
clearances
and side panel sizes are determined
by the many
installation
options
available.
Side panels must be used
whenever
the sides of the refrigerator
will be exposed.
Side panels are not required when refrigerator
is
installed into an enclosure
or between
pantry and oven
cabinets.
IMPORTANT - Side panels, 1/2" minimum
thickness
are required when using FRAMELESS
CABINETS.
• Field installed custom panels, Lexan _ or stainless
steel panels are required.
The door panels and grille
panel sizes vary to accommodate
the kit being used.
• The supplied toekick is vented and must remain
unobstructed
for proper air circulation.
Optional
Panel
Kits:
• ZWBC36: Black LexanCR_
Panel Kit
• ZWWC36: White Lexan_ Panel Kit
• ZWSC36:Stainless Steel Panel Kit
Optional
Custom
Trim
Kits:
• ZKHCI: For installation of a custom handle of your
choice onto 1/4"Panels.
• ZKTC36Lor ZKTC36R:For installation of 3/4" thick
custom panels.
• ZKHTCI: For installation of a custom handle of your
choice onto 3/4" thick panels. (This kit must be used in
combination with ZKTC36Lor ZKTC36R.
• ZKHCSSI: Tubular Stainless Steel handles for 1/4"
thick panels.
• ZKHTCSSI: Tubular Stainless Steel handles for 3/4"
thick panels.
• ZGC2:1/4" grille panel frame side pieces for 83-1/2
and 84-1/2"installation heights. Factory set height is
84".
Additional
Specifications
• A 115volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be
located on rear wall as shown.
• Water line can enter opening through the floor or
back wall. The water line should be 1/4"O.D. copper
tubing between the cold water line and water
connection location, long enough to extend to the
front of the refrigerator. Installation of an easily
accessible shut off valve in the water line is
recommended.
Clearances:
• If the refrigerator
is to be installed in a corner:
A 4" clearance
is required on the hinge side for a 90 °
door opening and access to fresh food drawers.
A 10"
clearance
is required on the hinge side for removal of
pans.
Advertisement
