Advertisement
ZKHTC1
Trim Kit (For 3/4" Panels)
Support
For
CIIStOlll
H;_nclles
Kit
Contents
Right hand door swing models are illustrated
in these
instructions.
Follow these instructions
for left hand
models.
Toolsandmaterials required:
• #2 Phillips screwdriver
• Drill and appropriate bits
• Custom door panels
• Custom handles
• Safety glasses
Note:This kit must be used in combination with ZKTC36L
or ZKTC36R trim kit for 3/4" panel trim.
Part List:
A. Fresh food handle extrusion (for left hand models)
B. Fresh food handle extrusion (for right hand models)
C. Freezer drawer extrusion
This kit provides the necessary
framework
to install
custom handles,
ofyour
choice, onto 3/4" thick
decorator
door panels. (Handles not included.)
The
door extrusions
allow the custom handles to be
secured to the door structure,
rather than the door
panels.
• Select fresh food handle extrusion
for your model,
discard
other fresh food extrusion.
Before
you
begin
3/4" custom door panels must be routed to accommo-
date these door handle extrusions.
Rout the panels as
illustrated,
1/4" deep, and 1-13/16" wide on the handle
side of the fresh food panel and the top end of the
freezer panel.
Refer to installation
instructions
for ZKTC36L or
ZKTC36R trim kit for 3/4" custom panels:
• Follow Step 1 to remove the standard aluminum
trim.
• Follow Steps 2 and 3 to attach new 3/4" trim pieces
and to install panel support brackets.
FreshFoodPanel
Back Side
Handb Side
FreezerDrawerPanel
Handb
End
Caution: Optimal final appearance depends on careful
routing depth. Do not exceed 1/4" routing depth
28
Advertisement
