Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Connecting Antenna
Make sure that the power switch of the monitor is turned off.
Speaker (R)
antenna
When the "ANT" terminal is connected to out door antenna is fead of CATV system, please note that a good antenna
adaptor is necessary. see the diagran on the right.
Precautions when connecting the antenna
Precautions when connecting the antenna
• Clamp section A using pliers when installing the coaxial cable. If other types of adaptors are used, be sure
• Please use a coaxial cable which is free from interference to connect the antenna. Avoid using a parallel flat
that the core and shielding are good.
feeder wire as interference may occur, causing reception to be unstable and stripe noise to appear on the
screen.
• Please use a coaxial cable which is free from interference to connect the antenna. Avoid using a parallel flat
• Avoid using indoor antenna as this may be affected by interference. Please use CATV net or outdoor
feeder wire as interference may occur, causing reception to be unstable and stripe noise to appear on the
screen.
antenna.
• Keep the power cord as far away from the antenna wire as possible.
• Avoid using indoor antenna as this may be affected by interference. Please use CATV net or outdoor
antenna.
• Keep the power cord as far away from the antenna wire as possible.
If there are noise appearance in the picture of VHF-Low band channel, please use the double-shielded cable (not
provided) for RF LEADS to reduce the noise.
• For safety, install an external antenna conforming to AS1417.1 (applicable for Australia only)
If there are noise appearance in the picture of VHF-Low band channel, please use the double-shielded cable (not
provided) for RF LEADS to reduce the noise.
Monitor rear panel
Power
cord
20 18
16
14
12
10
8
6
4
2
21 19
17
15
13
11
9
7
5
3
1
Speaker (L)
39
Advertisement
Table of Contents
