Size Switching; Input Signal Screen Display - Hitachi LCD Monitor User Manual

Size Switching

Each time the ZOOM button of the remote control is pressed, the screen display area will change in sequence and the
status will be displayed at the bottom of the screen.
Display area selection diagram (RGB input)
Processes such as compression (thinning) and expansion are performed for the above signal display. Because of this, there is a possibility that
flicker may become noticeable on Zoom (1 ~ 3) depending on the display contents. If this occurs, turning the Vertical Filter On
reduce the flicker.

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the RECALL button of the remote control.
• The display will go out in approximately 6 seconds.
RGB
Off-timer
On-timer
16
Normal Full
*
Real Zoom3 Zoom2
RGB2
RGB
H : 48.4kHz
V : 60.1 Hz
-- -- Min.
OFF
-- -- : -- --
ON
i + I / II
A / B 2- 4- 12
MENU
P+
- +
OK
P-
D VD
FREEZE
ZOOM
Zoom1
Input mode
Signal mode
Input horizontal frequency
Input vertical frequency
RECALL button
ZOOM button
can
21