Table of Contents
Advertisement
Connecting the IR (Infrared Receiver)
Before plugging the Display into the mains supply, connect the supplied IR receiver to the IR input on the
Display. Place the IR receiver in sight of your own remote control. Simply operate your remote control whilst
pointed at the IR receiver and it will relay the control signal to your Display.
Turning the Display On/Off
Press the Standby button on the remote or by pressing and holding the joystick on rear left of the Display to
switch it on from standby or to switch it into standby mode.
LED Status
Power LED not lit
Power LED lit
Power LED flashing (slow)
Power LED flashing (fast)
Joyst�ck
V+
V-
Status of the monitor
Power on
Power off (Standby mode)
Scheduler active
Power up/down and software update
English - 8 -
Advertisement
Table of Contents
