MK Diamond Products MK-370EXP Owner's Manual page 38

MK-370EXP SAW
"Rodding" cooling channels is performed by inserting a small wire rod through the
NOTE:
cooling inlet on top of the Blade Guard and directing the rod out through each of the
cooling flow tubes located on the underside of the Blade Guard. The cooling channels
should be "rodded" until all ports are free of foreign debris.
BLADE STOPS TURNING
(A)
Verify all plugs are fully
installed
(K)
Rod Cooling Channels
and recheck flow
(B)
Check to see if the wall outlet
Ground Fault Circuit Interrupter
(GFCI) is tripped. Verify circuit
breaker not tripped. If tripped,
reset once
38
TROUBLESHOOTING
(C)
Check power source voltage
is 120v – if not 120v, move to
another circuit