MK Diamond Products MK-370EXP Owner's Manual page 35

MK-370EXP SAW
45° ALIGNMENT VERIFICATION
The 45° Alignment Verification is done to ensure the blade will cut tile at a 45° angle.
NOTE:
If the blade is misaligned following this alignment procedure, return the saw to MK Diamond for
repair. The Diamond Blade must be removed and reinstalled when removing the Blade Guard.
Blade Guard retaining
(A)
Remove Blade Guard
(If not done Previously)
(D)
Verify Blade is even
across all points of Square
and there are no gaps
between Blade and Square
Rotate Knob Counter-
clockwise to loosen
wing nut
Position the Cutting Head
to the 45° Cutting Angle
To Adjust 45° Cutting
45°Adjustment Screw
No Gaps between
Blade and Square
(G)
Verify Blade is now even
across all points of Square
(B)
Upper
Screw
(E)
Angle, locate the
Repeat steps A to G until Blade is
even across all points of Square
35
TROUBLESHOOTING
(C)
Place Square on the Movable
Cutting Table and position the
Square against the Blade
(F)
Rotate 45° Adjustment Screw
clockwise or counter-
clockwise to realign 45°
Cutting Angle
(H)
Square