MK Diamond Products MK-370EXP Owner's Manual page 33

MK-370EXP SAW
ALIGNMENT SCREW, 90° VERIFICATION
90º- alignment verification will ensure that the blade will cut the tile straight up and down and
not at an angle.
NOTES:
If the blade is misaligned following this alignment procedure, return the saw to MK Diamond
for repair. The Diamond Blade must be removed and reinstalled when removing the Blade
Guard.
Rotate Knob Counter-
clockwise to loosen
(A)
Position the Cutting Head
to the 45° Cutting Angle
(D)
Position the Square on
Movable Cutting Table
against the Diamond Blade
HORIZONTAL ROUGH ALIGNMENT
The Horizontal alignment will ensure that straight cuts (or Rip Cuts) are made.
1/4-inch Wrench
Rotate Clockwise or
Counterclockwise to
Adjust Height
(A)
Position Cutting Head
to normal Cut Depth
Lower
Screw
(B)
Locate the 90°
Adjustment Screw
No gaps between
Blade and Square
(E)
Verify the Diamond Blade
is Square to the Movable
Cutting Table
(B)
Loosen front and rear
Guide Bar Retaining Bolts
33
TROUBLESHOOTING
(C)
Rotate 90° Adjustment Screw
clockwise or counter-clockwise
to realign Cutting Head
(F)
Repeat Steps A to E as
necessary to align the
Cutting Head
(C)
Move Guide Rail and Table
until the Blade is centered in
Cutting Groove