MK Diamond Products MK-370EXP Owner's Manual page 23

MK-370EXP SAW
DIAGONAL CUTTING
NOTE:
To cut diagonal, the Dual 45º Flat Angle Guide (MK Diamond Part No. 134557-MK)
should be used.
CAUTION
(A)
Remove the Adjustable
Cutting Guide
If Cutting the tile in two equal halves, align the tile in the V-notch of the Movable Cutting Table
Ruler/Stop.
Ruler/Stop
(D)
Position the tile against the
Dual 45º Flat Angle Guide
and the Ruler/Stop
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed.
Place the Dual 45º Flat
Angle Guide on the Ruler/
(G)
Perform the cut
(B)
Stop
(E)
Turn the motor ON
Turn the motor OFF when
work is complete
23
OPERATION
(C)
Position the Dual 45º Flat
Angle Guide and tighten
the retaining knob
(F)
Verify cooling flow on both
sides of the blade
(H)