MK Diamond Products MK-370EXP Owner's Manual page 32

MK-370EXP SAW
MOVABLE CUTTING TABLE ALIGNMENT VERIFICATION
This will verify the Movable Cutting Table is aligned to the frame of the saw.
NOTE: If the blade is misaligned following alignment verification, attempt to align using Alignment
Screw, 90º Verification. The Diamond Blade must be removed and reinstalled when
removing the Blade Guard.
Blade Guard
retaining wing nut
(A)
Remove Blade Guard
(D)
Move Square to wheel
assembly side of the
cutting table
(G)
Move Wheel Assembly up or
down to Square the Movable
Cutting Table
(B)
Place Square on guide bar
side of cutting table
(E)
Verify Wheel Assembly side
of Movable Cutting Table
height
is same as Guide Bar side
(H)
Check that there is no gap
between the Square and
the wheel assembly side of
frame
32
TROUBLESHOOTING
Lock in position
If gap exists, loosen Movable
Cutting Table Wheel
Square
No Gap
Tighten Movable Cutting
Table Wheel Assembly
(C)
(F)
Assembly
(I)