In Sta 11 A Ti On - Jenn-Air JXT8136ADS Installation Manual

INSTALLATION
AddBlockings
.rear
Dimensionsof
Support Arms
2325"
,/
/
/
FastenCeiling Plate
Support Arms with
Tabs position
Support Bracket
/"
/
/
,/
/
[
Mounting the RangeHood
1. Add and secure Nockings (minimum 2x4 studs)
onto ceiling joist.
2. Center,mark and fasten Ceiling Hate onto ceiling
where hood is to be hung. Make sure front of
bracket is facing as shown on diagram.
3. Determine height of hood, measure and attach four
support arms onto Nower unit with screws provided;
use predriHedhores on Nower unit and support arms.
Make sure tabs on top of the arms are facing out for the
front, and sideways for the rear, as shown on diagram.
Attach support "U" bracket.
4. Sridetelescopic duct covers onto the top of the
Nower unit.
5. Attach duct work to the ceiling and position the electrical.
6. Lift blower unit and fasten to Ceiling Plate(lock tabs on
support frame into slots on CeilingHate); secure support
frame to Ceiling Plate with screws provided.
7. Connect duct work and electrical to the blower unit.
(slide duct covers up to gain access to the top of the
blower unit).