56 Standard parallel port disabled
Try one or more of the following:
Press the arrow buttons until
•
The printer discards any data received through the parallel port.
Make sure the Parallel Buffer menu item is not set to Disabled.
•
56 Standard USB port disabled
Try one or more of the following:
Press the arrow buttons until
•
The printer discards any data received through the USB port.
Make sure the USB Buffer menu item is not set to Disabled.
•
57 Configuration change, some held jobs were not restored
Since the time the jobs were stored on the printer hard disk something has changed in the printer to invalidate the
held jobs. Possible changes include:
The printer firmware has been updated.
•
Paper input, output, or duplex options needed for the print job were removed.
•
The print job was created using data from a device in the USB port and the device is no longer in the port.
•
The printer hard disk contains jobs that were stored while installed in a different printer model.
•
Press the arrow buttons until
58 Too many bins attached
1
Turn the printer power off.
2
Unplug the power cord from the wall outlet.
3
Remove the additional bins.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer power back on.
58 Too many disks installed
1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the extra disks.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.
58 Too many flash options installed
Too many optional flash memory cards or too many optional firmware cards are installed on the printer.
Continue appears, and then press
Continue appears, and then press
Continue appears, and then press
Understanding printer messages
160
to clear the message.
to clear the message.
to clear the message.