Checking Operation - Kenmore 4558 - 30 in. Electric Drop-In Range Installation Instructions Manual

withthe screws p rovided (don'tforgetto insert
the shoulder screw intothe bracket).
5. Repeat steps 4 ontheotherside.
11.Install t he decorative l owertrimunder the door
using the screws p rovided w ith therange.
4. Checking Operation
Some models have manual controls. Refer to the
Owner's Guide and check all controls for correct
operation.
Some models are equipped with an electronic oven
control. Each of the functions has been factory checked
before shipping. However, it is suggested that you verify
the operation of the electronic oven controls once more.
Refer to the Owner's Guide for operation. Follow the
instructions for the Clock, Timer, Bake, Broil, Convection
(some models) and Clean (some models) functions.
Bake-After setting the oven to 350°F (177°C) for
baking, the lower element in the oven should become
red.
Broil-When the oven is set to BROIL, the upper element
in the oven should become red.
Figure 4
Ranges with a lift=up cooktop:
9. Anti-tip/anti-slide screws installation:
1. Slide the range to its final postion.
2. Lift the cooktop and secure range burner box to
cabinet with screws supplied to prevent range
from tipping (Figure 5).
10. Install the decorative lower trim under the door
using the screws provided with the range.
Anti--lip
mounting screws
2 on each side,
Clean (some models)-When the oven is set for a self-
cleaning cycle, the upper element should become red
during the preheat portion of the cycle. After reaching
the self-cleaning temperature, the lower element will
become red.
Convection (some models)-When the oven is set for
convection baking or roasting, both elements cycle on
and off alternately and the convection fan will turn. The
convection fan will stop turning when the oven door is
opened during convection baking or roasting.
IMPORTANT NOTE: A fan inside the upper rear part
above the oven (some models) provides additional
cooling of the oven electrical and electronic components.
The fan will continue to run after the oven has been
operating at high temperatures.
Figure 5
Model and Serial Number Location
The serial plate is located along the side of the oven door
in the open position.
When ordering parts for or making inquires about your
oven, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your oven.
Before You Call for Service
Read the Avoid Service Checklist and operating
instructions in your Owner's Guide. It may save you time
and expense. The list includes common occurrences that
are not the result of defective workmanship or materials
in this appliance.
Refer to the warranty in your Owner's Guide for our
toll-free service number and address. Please call or write
if you have inquiries about your product and/or need to
order parts.
7