Advertisement
continued
Connect water supply tine to 90° elbow installedin Step 6,
Open and close the door, Check to be sure door spring does
not rub against flit hose or water supply line
Fili Hose
Door
tng
Important:When opening and
closing the door, the door
spring should not touch the fill
hose if it does, bend water
valve bracket slightly to
provide clearance between
the springand the tilthose
Valve
Bracket
90 ° Eibow
HotWater
FigureQ
SupplyLine
Follow all local codes and ordinances.
DRAIN LINE PREPARATION
The molded end is designed to fit 5/8",3/4" or 1"diameter
connections to the air gap, waste tee or disposer,Cut on
premarked line as required for your installationas illustrated
in Figure R,
Note: DO NOT CUT CORRUGATED PORTIONOFHOSE
Cutting Lines
/,
/.
FigureR
Donot cutcorrugated
portionofhose
if the location requires a longer drain hose, add upto 42"of
length to the factory installedhose, Use 5/8" or 7/8" inside
diameter hose and a short section of copperwater pipe of
appropriatelength and diameter to connect the two hose
ends, Secure connection with appropriate clamps (not
supplied).
Note: TOTALDRAIN HOSELENGTHMUST NOT EXCEED
t0 FEETFORPROPERDRAINOPERATION
DRAIN LINE INSTALLATION
Connect drain Iine to air gap, waste tee or disposerusing
either Method I or Method 2 as previously determined. Refer
to Figure S or Figure T1
Secure connection using appropriate clamps (not supplied)°
Make sure drain hose is not kinked.
Method 1-Air gap with waste tee or disposer
Waste tee installation
Disposer installation
Figure$
Method 2-High drain loop with waste tee or disposer
Fasten tounderside
_ _
ofcountertop,
3;
Waste tee installation
FigureT
Fasten t o underside
ofcountertop
Disposer Installation
Note: BE SURETO REMOVEDRAIN PLUGFROMDISPOSER
BEFORE ATTACHINGDRAIN LINE DISHWASHERWILL NOT
DRAIN IF PLUGIS LEFTtN PLACE
Advertisement
