Advertisement
continued
Position the water supply line and house wiring on the floor of
the opening to avoid interference with base of dishwasher
and components under dishwasher,
Line
Supply
FigureL
Upright dishwasher and position in front of the cabinet
opening. Insert the drain hose into the hole previously drilled in
the cabinet wall, If a power cord is used, guide the end
through a separate hole cut for the electrical cord,
Power cord should be routed directly to the rear of junction box
avoiding contact with spring or other dishwasher components,
FigureM
""
Slide the dishwasher into the opening a few inches at a time.
As you proceed, pull the drain hose through the opening and
under the sink Make sure drain hose is not kinked under
dishwasher,. Check to be sure there is no interference with
water line and wiring,
DONOT PUSH
AGAINSTFRONT
DOORPANEL
WITH YOUR
KNEE.Damageto
the door panel
will occur_
Figure N
Route the water line and
electrical suppfy to their
connection locations
under the dishwasher,
Do not connect water
and electrical in this step
Level the dishwasher by adjusting the
four leveling legs individually for correct
alignment, See Figure D,
Dishwasher should be level left to right
and front to back for proper dish rack
operation and dishwasher performance.
Dishwasher door should be in alignment
with adjacent cabinets.,See Figure P,
Figure0
Open the door and positionthe dishwasher tub flange 3/4"
from the cabinet opening, Fastenthe dishwasher to the
underside of the countertop, using the 2 Phillips screws
provided in Step I Be sure screws are driven straight and
flush to avoid interference with door operation, See Figure P
Important:
Make sure that
dishwasher is
centered in the
opening and
there is no
interference with
cabinets when
opening or closing
the door. Interfer-
ence may cause a
water leak when
dishwasher is in
operation.
Advertisement
