Advertisement
Quick Links
for your new
Dishwasher
CAUTION:
• Before you begin--Read these instructions completely and carefully,
• IMPORTANT-Save these instructionsfor local inspector's use.
o IMPORTANT-OBSERVE ALLGOVERNINGCODESAND ORDINANCES°
• Note to Installer-Be sure to leave these instructionswith the Consumer.
• Note to Consumer-Keep these instructions with your Use& Care Book for future reference,
If you received a damaged dishwasher,
you should immediately contact your
dealer or builder
The dishwasher MUST be installed to allow for future removal
from the enclosure if service is required. Installation of this
dishwasher requires basic mechanical and electrical skills
Proper installation is the responsibility of the installer,
[] Two Phillips head eountertop mounting screws taped to dishwasher
Materials required:
[] 90° elbow
(3/8"NPT external thread on one end and
opposite end sized to fit water supply)
[] Thread seal tape
[] UL Listed Wire nuts (3)
Fornew installationsonly:
[] Air gap for drain hose, if required
[] Waste tee for house plumbing, i f applicable
[] Electrical cable or power cord, if applicable
[] Screwtype hose clamps
[] Strain relief for electrical connection
[] Hand shut-off valve (recommended)
[] Water line 3/8"rain copper or 1/2" rain plastic
[] Coupler for extending drain line, if applicable
Electrical Cable
or Power Cord
@G
ScrewTypeCiamps
ThreadSeal
StrainRelief
Tape
Wire Nuts
Gap
Tee
Coupler
Hot Water Line
®
Shut-Off
Valve
Tools required:
[] Phillips head and flat blade screwdrivers
[] Adjustable wrench (6"}
[] Level
[] Carpenters square
[] Measuring tape
[] Safety glasses
[] Flashlight
For new installations only:
[] Tubing cutter
[] Drill and appropriate bits
[] Ho}esaw set
MeasuringTape
Level
Advertisement
Related Manuals for Kenmore 36314071793
Summary of Contents for Kenmore 36314071793
- Page 1 Dishwasher for your new CAUTION: • Before you begin--Read these instructions completely and carefully, • IMPORTANT-Save these instructionsfor local inspector's use. o IMPORTANT-OBSERVE ALLGOVERNINGCODESAND ORDINANCES° • Note to Installer-Be sure to leave these instructionswith the Consumer. • Note to Consumer-Keep these instructions with your Use& Care Book for future reference, The dishwasher MUST be installed to allow for future removal If you received a damaged dishwasher, from the enclosure if service is required.
-
Page 2: Drain Requirements
• The rough cabinet opening must have a minimum width and depth of 2#', and approximately 34-1/2" high from floor to underside of the countertop, Figure A . The back wall should be free of pipes or wire& Figure A ThisWallArea •... - Page 3 WARNING FORPERSONAL SAFETY: R EMOVEHOUSE FUSEOROPENCIRCUITBREAKER BEFORE BEGINNING INSTALLATION, DO NOT USEAN EXTENSIONCORDORADAPTERPLUG WITH Tills APPLIANCE,. ELECTRICALREQUIREMENTS: • This appliance must be supplied with 120V, 6 0 Hz, and connected to an individual, properly grounded branch circuit, protected by a 15 or 20 ampere circuit breaker or time delay fuse, •...
- Page 4 [Step 4 Bernoveacesspanelandtoekml(: Removethe two screws below the access panel and set aside for reuse Removeaccess panel by backing out the two ts opened, screws located between the door and access panel. These screws are secured to access panel with plastic retainers, Back Out Locate the 2 Phillips head countertop mounting screws 2 Screws...
- Page 5 continued Slide the dishwasher into the opening a few inches at a time. Position the water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher As you proceed, pull the drain hose through the opening and and components under dishwasher, under the sink Make sure drain hose is not kinked under dishwasher,.
-
Page 6: Drain Line Installation
continued Connect water supply tine to 90° elbow installedin Step 6, Important:When opening and Open and close the door, Check to be sure door spring does closing the door, the door spring should not touch the fill not rub against flit hose or water supply line hose if it does, bend water Fili Hose valve bracket slightly to... - Page 7 [Step 5 ::co.. ct Verify that power is turned off at source, If power cord is Locate the three dishwasher wires (white, black, and green) used, plug it into the wal! outlet and go to Step 16.If dish- with the stripped ends. Insert the three wires through the washer is to be directly wired to house wiring, continue with small hole in the junction box bracket Using wire nuts of this step.
- Page 8 V!/t ixx continued Refer to Figure V Place the toekick against the legs of the dishwasher. Align the access panel to the dishwasher and tighten the two access panel screws, Align the toekick and make sure the bottom edge is against the floor. Insert and tighten the two toekick attachment screws, making sure the qSghten 2 Access P anel Screws...