Advertisement
WARNING
FORPERSONAL SAFETY: R EMOVEHOUSE
FUSEOROPENCIRCUITBREAKER BEFORE
BEGINNING INSTALLATION,
DO NOT USEAN EXTENSIONCORDORADAPTERPLUG
WITH Tills APPLIANCE,.
ELECTRICALREQUIREMENTS:
• This appliance must be supplied with 120V, 6 0 Hz, and
connected to an individual, properly grounded branch
circuit, protected by a 15 or 20 ampere circuit breaker or
time delay fuse,
• Wiring must be 2 wire with ground.
• Ifthe electrical supply provided does not meetthe
above requirements, call a licensed electrician before
proceeding..
GROUNDING INSTRUCTION
This appliance must be connected to a grounded metal,
permanent wiring system, or an equipment-grounding conduc-
tor must be run with the circuit conductors and be connected
to the equipment-grounding terminal or lead on the appliance,
WARNING
THE IMPROPER CONNECTION OFTHEEQUIPMENT-
GROUNDING CONDUCTOR CANRESULT IN A RISK
OFELECTRIC SHOCK.CHECK WITH A QUALIFIED ELECTRICIAN
ORSERVICE REPRESENTATIVE IFYOUAREIN DOUBT
WHETHER THEAPPLIANCEIS PROPERLY G ROUNDED.
CABINET PREPARATION & WIRE ROUTING
• Wiring may enter from either side, the rear, or from the floor
within the shaded area shown in Figure E
• Cut hole 1-1/2"max. dia. within the shaded area to admit the
electrical cable or power cord..The hole must be free of
sharp edges. If the cabinet wall partition is metal, the edge
of the hole must be covered with a rubber protector.
ELECTRICALCONNECTIONS TO DISHWASHER
Electrical connection is on right side of dishwasher,
• For cable direct connections the cable must be routed as
shown in Figure E Cable must extend a minimum of 24"from
the rear walt.
• For power cord connections, install a 3-prong grounding
type receptacle in the rear wall of sink cabinet next to the
dishwasher The receptacle should be installed at least
6", but not more than 18",from the cabinet opening for
dishwasher.
1.The hot water line may enter from either side, the rear or from
the floor within the shaded area shown in Figure E
2. Cut a hole approximately 1-1/2" dia. within the shaded area to
admit the line.
3, Turn off the water supply.
4. Install a hand shut-off valve in the supply Iine in an accessible
location, such as under the sink..(The shut-off valve is optional,
but recommended and may be required by local codes.)
5. Water connection is on left side of dishwasher. Install the hot
water inlet line, using no less than 3/8" 0,D copper tubing or
1/2"OD. plastic tubing. Route line as shown in Figure E Extend
the water tine forward at least 19"from rear wall
6. Adjust the water heater to deliver water between the
temperatures of 120°Fand 150°E
7. Flush water line to clean out debris.
B.The water pressure of the hot water supply line must be
20q20 PSI
Valv_
Hot L_::::
From
Cabinet
CabinetFace
FigureF
Advertisement
