Table of Contents
Advertisement
continued
not rub against fill hose or water supply line.
IStep 13, co,.e='W.ter.uppUv
:
J
Connect water supply line to 90° elbow installed in Step 6.
Important: Whenopening and
Open and close the door_Check to be sure door spring does
Water Valve Bracket
closing thedoor, t hedoor
spring should not touch the fi[E
HotWater
SupplyLine
hose tf it does, bend water
valve bracket slightly to
provide clearance between
the spring end the fi!] hose
Figure Q
!Step 14 ico.. ctd,ai,,.e
Follow all local codes and ordinances
DRAIN LINE PREPARATION
The molded end is designed to fit 5t8",3/4"or I" diameter
connections to the air gap, waste tee or disposer Cut on
premarked line as required for your installation as illustrated
in Figure R
Note: DO NOT CUT CORRUGATED PORTIONOFHOSE,
Cutting Lines
Figure R
Donot CUt c orrugated
portionof hose
If the location requires a longer drain hose, add up to 42"of
length to the factory installed hose° Use 5/8" or 7/8" inside
diameter hose and a short section of copper water pipe of
appropriate length and diameter to connect the two hose
ends. Secure connection with appropriate clamps (not
supplied).
Note: TOTAL DRAIN HOSELENGTHMUST NOT EXCEED
10 FEETFORPROPERDRAIN OPERATION
DRAIN LINE INSTALLATION
Connect drain line to air gap, waste tee or disposer using
either Method I or Method 2 as previously determined Refer
to Figure S or Figure T.
Secure connection using appropriate clamps (not supplied),
Make sure drain hose is not kinked.
Method 1-Air gap with waste tee or disposer
_.___
_
__
i
Waste tee installation
Disposer Installation
Figure S
Method 2-High drain loop with waste tee or disposer
Fasten t ounderside
_ _
ofcountertop,
lll
l
Min
1
Waste tee installation
Fasten to underside
.._
of countertop
.............
I
Disposer Installation
FigureT
Note: BE SURETO REMOVEDRAIN PLUGFROMDISPOSER
BEFORE ATTACHINGDRAIN LINE. DISHWASHERWILL NOT
DRAIN IF PLUGIS LEFTIN PLACE,
Advertisement
Table of Contents
