Gas Connections - Haier CGDE450AW User Manual And Installation Instructions

Gas & electric dryer
Table of Contents

Advertisement

Available languages

Available languages

English
4. Thread a UL approved 30 Amp power cord. NEMA 14-30 type ST or SRDT
through the strain relief.
5. Attach the green power cord ground wire to the cabinet with green ground
screw.
6. Attach the white (neutral) power cord conductors and the green ground wire
from the dryer harness to the brass-colored center terminal on the terminal
block. Tighten the screw securely.
7. Attach the red and black power cord conductors to the outer brass-colored
terminals on the terminal block.
WARNING: Do not make a sharp bend or crimp the wiring /conductor at
8. Tighten the screws securing the cord restraint firmly against the power cord.
9. Tighten the strain relief nut securely so that the strain relief does not turn.
10. Reinstall the terminal block cover.

GAS CONNECTIONS

GAS DRYER (GDG450AW)
NOTE: DO NOT connect the dryer to L.P. gas service without converting the
gas valve. An L.P. Conversion Kit must be installed by a qualified gas
technician.
1. Remove the shipping cap from gas pipe at the rear of the dryer.
2. Connect a 1/2 inch (1.27cm) I.D. semi-rigid or approved pipe from gas
supply line to the 3/8 inch (0.96cm) pipe located on the back of the dryer.
Use a 1/2 inch to 3/8 inch (1.27cm to 0.96cm) reducer for a connection.
Apply an approved thread sealer that is resistant to the corrosive action of
liquefied gases on all pipe connections.
3. Open the shutoff valve in the gas supply line.
4. Test all connections by brushing on a soapy water solution. NEVER TEST FOR
GAS LEAKS WITH AN OPEN FLAME.
5. Connect the exhaust duct to the outside exhaust system. Use duct tape to seal
all joints.
6. With the dryer in its final position, adjust one or more of the legs until the
dryer is resting solid on all four legs. Place a level on top of the dryer. THE
DRYER MUST BE LEVEL AND RESTING SOLID ON ALL FOUR LEGS.
7. Plug the power cord into a grounded outlet. NOTE: check to ensure power is
Off at circuit breaker/fuse box before plugging the power cord into the outlet.
15
connections.
CAUTION

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gde/gdg450awGde 450 awGdg 450 awGde450awGdg450aw

Table of Contents