Timed Dry Cycle - Haier CGDE450AW User Manual And Installation Instructions

TIMED DRY CYCLE

1. Turn the knob to any program except "Off" to power on. The control panel
will beep once and the dryer will change from "Off" to the operating status. If
Start/Pause button is not pressed five minutes after powering on, the dryer will
automatically return to Off status.
2. Set the cycle select dial to Timed Dry Cycle.
3. There are 3 preprogrammed times, Timed Dry (5 Settings), Gentle Dry and
Touch Up.
4. Press "Timed Dry" button to set the required drying time;
Press "Temp" button to set the required drying temperature.
In "Touch Up" cycle only a 20 minutes Timed Dry can be selected.
Temp in "Touch Up" cycle is High Medium Low.
Temp in "Gentle Dry" cycle is low only.
5. When starting the machine close the door first, then press the "Start/Pause"
button. If a pause is needed during drying, press this button. Pressing again
will resume operation.
6. Regardless of the dryer status (drying, pause or cool down), by turning the dial
to "Off" position, the "Off" indicator light will flash for 5 seconds and then
go into stand by mode. When the machine is running, turn the dial in any
direction, the cycle will automatically turn "Off".
Note: To change the cycle press "Start/Pause", turn dial to new selection and
press "Start/Pause" again.
English
22