Table of Contents
Advertisement
DVG-3016S/3032S User's Manual
FAX/Modem: Enable this line to detect if there is a fax tone and transfer the call to a fax line.
Function
Disable
T.38 Fax
T.30 Fax
T.30
Fax/Modem
T.30 Only
T.38 Native
NOTE: When a fax tone is detected from the call, the gateway will automatically switch from voice
mode to fax mode. Hence, the fax settings will be temporarily applied to a specific port which
detects the fax tones, instead of its default voice settings.
Trunk Hunting Order: To set FXO dial-out mode when there is an incoming call dialed FXO
representative number.
First Idle: The gateway will assign each unassigned call from first FXO line.
Sequential: The gateway will automatically assign the first unassigned call to the first FXO line. The
second FXO line will dial the second unassigned call out. Each line will be used.
D-Link Systems, Inc.
Fax Detection Content of SDP of re-INVITE
No
Yes
re-INVITE with T.38 and T.30
Yes
re-INVITE with T.30
Detect CED
re-INVITE with T.30
only
N/A(All the calls use T.30
No
codec of RTP stream, not
need to change codec.)
Yes
re-INVITE with T.38
Receive re-INVITE with T.38
N/A
Accept and change RTP to T.38
Accept and change RTP to T.38
Accept and change RTP to T.38
Accept and change RTP to T.38
Accept and change RTP to T.38
Accept and change RTP to T.38
Telephony Settings
20
Advertisement
Table of Contents
