Getting Started; Scan Barcodes (Add Items To Memory); Clear Barcodes (Remove Items From Memory) - Opticon OPN 2001 User Manual

Getting Started

3
3.1 Scan barcodes
(Add items to memory)
Point the scanner towards a barcode (such as the sample code as
shown below) and press and hold the Scan button. Make sure that
the laser beam covers the whole barcode including a fair white
margin. When the barcode is not decoded immediately, then move
the scanner towards the barcode. Make sure that the scanner is
held at a slight angle.
While the scanner is reading, the laser is visible, and the green LED
is flashing. After a few seconds, the laser is shut off, and the LED
starts flashing orange, indicating that you should release the button
and try again.
Note: The OPM2001 is a Class I laser product conforming to the strictest
laser safety standards. However, we recommend you to avoid looking directly
into the laser beam.
3.2 Clear Barcodes
(Remove items from memory)
Point the scanner towards a barcode and press and hold the small
Clear button. When the barcode is not decoded immediately, then
move the scanner towards the barcode and make sure that the
scanner is held at a slight angle.
While the scanner is reading, the laser is visible, and the orange
LED is flashing. When the barcode is decoded, the scanner
searches in its memory for this barcode, and deletes the first match
(if there are more of these barcodes, they are not deleted). If the
barcode was not found in memory, the scanner will issue a low error
beep.
-
6 OPTICON OPN 200
*1234*
1