Installing The Scanner; Connecting The Scanner Module Cable; Connecting The Power Module - NCR 7890 User Manual

Installing Your 7890 Scanner

Installing the Scanner

Connecting the
Scanner Module
Cable
Connecting the
Power Module
3-12
1 Connect one end of the Scanner Module Cable to the
7890 Scanner.
2 Connect the other end of the Scanner Module Cable
to the box on the end of the Interface Cable.
1 Verify that you have the correct Power Module for
your electrical outlet.
2 Connect the power connector on the end of the
Power Module Cable to the box on the end of the
Interface Cable.
Plug the Power Module into an electrical outlet.
3
When the 7890 Scanner receives power, the
diagnostics checks various hardware components. If
the scanner passes the diagnostic tests, it gives a
"ready" indication; four quick beeps of increasing
frequency and two flashes of the Status Indicator.
Does the scanner give "ready" indication?
User's Guide
Yes
End of procedure.
No
Continue to Chapter 6
Troubleshooting Your 7890
Scanner