Connect Wireless Devices; Wlan; Wi-Fi Protected Setup (Wps); Connect The Broadband (Dsl) - Technicolor TD5130 Setup & User Manual

2.3

Connect Wireless Devices

Before connecting wireless devices to the Wireless Gateway, configure the wireless security settings of
your Wireless Gateway (see
password you have set, you need the SSID and the password to connect devices to your Wireless
Gateway.
2.3.1

WLAN

From the wireless device end, search for the Wireless Gateway network name (SSID), and enter the
passphrase to connect.
The SSID and passphrase are the ones you have set in the Wireless Security Settings (see
Security Settings
2.3.2

Wi-Fi Protected Setup (WPS)

Press and hold the WPS button of the Wireless Gateway for at least 8 seconds and press the WPS button
on the WPS-enabled device to start pairing.
2.4

Connect the Broadband (DSL)

1 Connect one end of the RJ-11 cable to the DSL port of your Wireless Gateway.
2 Connect the other end of the RJ-11 cable to a wall jack with DSL service.
2.4.1

Use a Splitter

You need a splitter when connecting the Wireless Gateway to the wall jack that also connects to a
telephone.
1 Plug the splitter to the wall jack with DSL service.
2 Connect one end of the RJ-11 cable to the DSL port of your Wireless Gateway.
3 Connect the other end of the RJ-11 cable to the MODEM port of the splitter.
4 Connect the telephone to the LINE port of the splitter using another RJ-11 cable.
Copyright © 2012 Technicolor. All rights reserved.
DMS-CTC-20120508-0000 v1.0.
"To Set up Security Settings
on page 41").
SETUP & USER GUIDE
on page 41"). Take note of the SSID and the
"To Set up
8