Connect Wired Devices; Connect Wireless Devices; Wlan; Wi-Fi Protected Setup (Wps) - Technicolor TD5136 User Manual

Wireless adsl2+gateway

Table of Contents

Installation

2.2

Connect devices such as computers, printers, and other Ethernet-enabled devices to

the LAN port of the Wireless Gateway.

NOTE:

When setting up the Wireless Gateway for the first time, connect the host

computer via Ethernet connection.

1. Connect one end of the RJ-45 cable to one of the Ethernet (1, 2, 3, 4) ports of

your Wireless Gateway.

2. Connect the other end of the RJ-45 cable to the Ethernet port of the computer.

3. Repeat the above steps to connect other computers to the Wireless Gateway

via Ethernet connection.

4. To connect more than four computers, use a hub or switch. Connect one end

of an RJ-45 cable to the hub or switch and the other end to the computer.

2.3

Before connecting wireless devices to the Wireless Gateway, configure the wireless

security settings of your Wireless Gateway (see "Error! Reference source not found."

on page Error! Bookmark not defined.). Take note of the SSID and the password you

have set, you need the SSID and the password to connect devices to your Wireless

Gateway.

From the wireless device end, search for the Wireless Gateway network name (SSID),

and enter the passphrase to connect.

NOTE:

The SSID and passphrase are the ones you have set in the Wireless Security Settings

(see "Error! Reference source not found." on page Error! Bookmark not defined.).

Press and hold the WPS button of the Wireless Gateway for at least 8 seconds and

press the WPS button on the WPS-enabled device to start pairing.

Wireless ADSL2+ Gateway

Connect Wired Devices

Table of Contents