US Robotics USR Call Director User Manual

USR CALL DIRECTOR PROGRAMMING AND QUICK REFERENCE GUIDE
REGISTER NUMBER PROGRAMMABLE FEATURE PROGRAM RANGE
0= OFF
01 FAX Tone Detection
1= ON
0= OFF
02 Protected Hook Flash
1= ON
0= OFF
03 Unanswered Call Silent Transfer
1= ON
0= FAX
04 Silent Transfer Destination
1= MODEM
0= OFF
05 Pulse Detection
1= ON
0= OFF
06 Call Override
1= ON
0= OFF
07 Unrestricted Manual Transfer
1= ON
0= OFF
08 Answering Machine Silent Transfer
1= ON
DIGITS 0-9 * AND #
11 Security Access Code For VOICE Ports
4 DIGITS MAXIMUM
DIGITS 0-9 * AND #
12 Security Access Code For FAX Port
4 DIGITS MAXIMUM
DIGITS 0-9 * AND #
13 Security Access Code For MODEM Port
4 DIGITS MAXIMUM
14 Rings To Answer 0 TO 10 RINGS
15 Maximum Rings 4 TO 30 RINGS
IMPortant SaFety InStrUctIonS - "Save theSe InStrUctIonS" 8. Do not allow anything to rest on the power cord. Do not locate this product
When using your telephone equipment, basic safety precautions should al- where the cord will be abused by persons walking on it.
ways be followed to reduce the risk of fire, electric shock and injury to persons, 9. Do not overload wall outlets and extension cords as this can result in the
including the following: risk of fire or electric shock.
1. Read and understand all instructions. 10. Never push objects of any kind into this product through cabinet slots as
2. Follow all warnings and instructions marked on the product. they may touch dangerous voltage points or short out parts that could
3. Unplug this product from the wall outlet before cleaning. Do not use liquid result in risk of fire or electric shock. Never spill liquid of any kind on this
cleaner or aerosol cleaners. Use a damp cloth for cleaning. product.
4. Do not use this product near water, for example, near a bathtub, wash-bowl, 11. To reduce risk of electric shock, do not disassemble this product, but take
kitchen sink or laundry tub, in a wet basement or near a swimming pool. it to a qualified serviceman when some service or repair work is required.
5. Do not place this product on an unstable cart, stand or table. The product Opening or removing covers may expose you to dangerous voltages or
may fall causing serious damage to the product. other risks. Incorrect reassembly can cause electric shock when the appli-
6. This product should never be placed near or over a radiator or heat reg- ance is subsequently used.
ister. This product should not be placed in a built-in installation unless 12. Unplug this product from the wall outlet and refer servicing to qualified
proper ventilation is provided. service personnel under the following conditions:
7. This product should be operated from only the type of power source indi- A) When the power supply cord or plug is damaged or frayed.
cated on the marking label. If you are not sure of the type of power supply B) If liquid has been spilled into the product.
to your home, consult your dealer or local power company. C) If the product has been exposed to rain or water.
FACTORY PRESET PROGRAMMING / INSTALLATION RECOMMENDATIONS
IF PHONE AND FAX ARE BEING USED IN AN INSTALLATION,
ON
PROGRAM THIS FEATURE "ON"
WITH OLDER KEY AND PBX PHONE SYSTEMS, YOU MAY NEED TO
OFF
PROGRAM THIS FEATURE "ON"
"UCST" ROUTES ALL UNANSWERED AFTER-HOURS CALLS TO A FAX
OFF
OR MODEM PORT
THIS FEATURE DETERMINES WHICH DEVICE WILL RECEIVE A CALL
FAX
AFTER IT HAS BEEN "SILENTLY TRANSFERRED"
IF YOU HAVE PULSE DIAL PHONES AND WISH TO TRANSFER OR
OFF
"GRAB" A CALL – PROGRAM THIS FEATURE "ON"
IF THE USR CALL DIRECTOR IS INSTALLED AT A WALLJACK AND
OFF YOU WANT TO ANSWER A CALL FROM ANY EXTENSION PHONE-
PROGRAM "ON"
GIVE TRANSFER ABILITY ANY TIME, FROM EITHER PARTY FROM
ON
ANY PHONE, RECOMMENDED PROGRAMMING "ON"
AFTER ANSWERING MACHINE TIMES OUT, CALL WILL BE ROUTED TO
OFF
FAX OR MODEM PORT
THIS REGISTER CONTAINS THE CODE FOR TRANSFER OF A FAX OR
*1
MODEM CALL TO DEVICES CONNECTED TO VOICE 1 & 2 PORTS
THIS REGISTER CONTAINS THE CODE FOR TRANSFER OF A VOICE OR
*2
MODEM CALL TO FAX/PC FaxCard CONNECTED TO FAX PORT
THIS CODE IS USUALLY SENT BY A CALLING MODEM – WE
*3 RECOMMEND PROGRAMMING A FOUR DIGIT CODE FOR SECURITY
PURPOSES
IF THE USR CALL DIRECTOR IS USED ON A KSU OR PBX SET TO "0" –
0 RINGS HOME INSTALLS W/EXT. PHONE ACCESS, PROGRAM
NEEDED NO. OF RINGS
THIS FEATURE CONTROLS THE NO. OF TIMES A DEVICE (VOICE, FAX,
8 RINGS MODEM) IS RUNG BY THE USR CALL DIRECTOR
BEFORE DROPPING THE CALL
D) If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the op-
erating instructions because improper adjustments of other controls
mayresult in damage and will often require extensive work by a quali-
fied technician to restore the product to normal operation.
E) If the product has been dropped or the cabinet has been damaged.
F) If the product exhibits a distinct change in performance.
13. Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lightning.
14. Do not use the telephone to report a gas leak in the vicinity of the leak.
InStallatIon InStrUctIonS
1. Never install telephone wiring during a lightning storm.
2. Never install telephone jacks in wet locations unless the jack is specially
designed for wet locations.
3. Never touch non-insulated telephone wire or terminals unless the tele-
phone line has been disconnected at the network interface.
4. Use caution when installing or modifying telephone lines.
LIMITED WARRANTY
We warrant that if the USR Call Director, distributed by U.S. Robotics Corpora-
tion and purchased by you, proves to be defective in material or workmanship, we
will provide without charge, for a period of 1 year (USA ONLY), the labor and parts
necessary to remedy any such defect. Warranty commences on the date of purchase
by the original retail consumer.
The duration of any implied warranty of merchantability, fitness for a particular
purpose, or otherwise, on this product shall be limited to the duration of the appli-
cable express warranty set fourth above. In no event shall we be liable for any loss,
inconvenience or damage whether direct, incidental, consequential or otherwise re-
sulting from breach of any express or implied warranty, of merchantability, fitness
for a particular purpose, or otherwise with respect to this product, except as set forth
herein. Some states do not allow limitations on how long implied warranty lasts and
some states do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitations or exclusions may not apply to you.
To obtain service under this warranty, you must first request an RMA
number from our Technical Support Department by calling 877-762-0132.
Present the USR Call Director product with the RMA number and a copy of a
sales receipt (or credit card receipt) or other satisfactory proof of the date of
original retail purchase of the product to U.S. Robotics Corporation.
The AC power supply used with this product is covered under this warranty.
This warranty does not cover damage which results from accident, misuse, abuse,
improper line voltage, lightning strike, fire, flood, or damage resulting from unau-
thorized repairs or alterations performed by an unauthorized service center. This
warranty gives you specific legal rights, and you may also have other rights which
vary from state to state.
FCC REGISTRATION
This equipment complies with Part 68 of the FCC rules. On the bottom of this
equipment is a label that contains, among other information, the FCC Registration
Number and Ringer Equivalence Number (REN) for this equipment. You must,
upon request, provide this information to your telephone company. The REN is used
to determine the number of devices you may connect to the telephone line and still
have all those devices ring when your telephone number is called. In most, but not all
areas, the sum of the REN's of all devices connected to one line should not exceed
five (5). To be certain of the number of devices you may connect to your line, as
determined by the REN, you should contact your local telephone company to deter-
mine the maximum REN for your calling area. If your telephone equipment causes
harm to the telephone network, the telephone company may discontinue your ser-
vice temporarily. If possible, they will notify you in advance. But if advance notice
is not practical, you will be notified as soon as possible. You will be informed of your
right to file a complaint with the FCC. Your telephone company may make changes
in its facilities, equipment, operations or procedures that could affect the proper
functioning of your equipment. If they do, you will be notified in advance to give
you an opportunity to maintain uninterrupted telephone service. If you experience
trouble with the USR Call Director, please contact your retailer or U.S. Robotics
Corporation for information on obtaining service and repairs. The telephone com-
pany may ask that you disconnect this equipment from the network until the problem
has been corrected or until you are sure that the equipment is not malfunctioning.
This equipment may not be used on coin service provided by the telephone company,
and is not intended for use with party line service. This equipment is intended for use
only on loop start service, and will not operate on a ground start central office line.
USR Call Director
Phone/Fax/Modem Switch
User Manual
U.S. Robotics Corporation
1300 E. Woodfield Road
Suite 506
Schaumburg, IL 60173
847.874.2000 - Headquarters
877.762.0132 - Technical Support
www.usr.com