Replacing The Vacuum Motor Pages - Bissell ProHeat 2X 8920 Series Service Center Manual

REPLACING THE VACUUM MOTOR
Remove all wires.
Lift up firmly to unseat the seal and remove motor. Motor is not held in place with
screws.
Make sure the seal is correctly installed on the new motor:
Seal should not be covering the vent holes.
Seal should be positioned so the wire holders are on the correct side of the motor.
Issued: September, 2005
© 2005 BISSELL Homecare, Inc.
Bissell ProHeat 2X™ Service Center Guide
Page 16 of 22