Replacing The Post-Motor Filter - Bissell CleanView Plus 4207 Series User Manual

M
aintenance and care

Replacing the post-motor filter

use only a genuine bissell replacement
post-motor filter in your bissell cleanView
vacuum.
1. unplug the cleaner from electrical outlet.
2. the post-motor filter assists in the filtration
process to return clean air to the room.
Replace the post-motor filter every three to
six months. to access the post-motor filter,
remove the filter tray located below the easy
empty dirt tank. When the filter becomes
dirty, push the filter through the bottom of the
tray to clean or replace the filter.
NOTE: the white, pleated post-motor
filter may NOT be washed with
water or detergent. If dust and/
or debris accumulates on the filter,
gently tap the filter on the side of
a garbage container.
Checking rotating floor
brush and drive belt
You should check your vacuum cleaner's rotating
floor brush and drive belt regularly for wear or
damage. You should also clean the brush and
brush ends of strings, hair and carpet fibers.
these can wrap around the brush and hamper
its ability to effectively clean your carpet. also
remove any debris that has accumulated under
the brush cover.
1. unplug cleaner from electrical outlet.
2. place handle in low position and turn
vacuum cleaner over so bottom side is up.
3. Remove the seven screws with a phillips
head screwdriver. lift the brush cover off.
4. grasp rotating floor brush at both ends
and lift straight out of the vacuum foot.
slip off the belt.
5. clean strings, hair and other debris from
rotating floor brush, paying particular
attention to brush ends.
6. clean strings, hair and other debris from
motor pulley and drive belt areas.
7. check drive belt carefully for wear, cuts
or stressed areas, and replace if neces-
sary (see instructions on following page).
8. check air passageway for obstructions.
Remove debris from this area.
10
w w w . b i s s e l l . c o m
WARNING:
Do not operate cleaner with
damp or wet filters or without
all filters in place.
2.
Post-Motor
Filter
WARNING:
To reduce the risk of injury from
moving parts, turn off vacuum
cleaner and disconnect Power Plug
from electrical outlet.
Brush Cover
3.
Motor Pulley
4.
8.
Air Passageway
8 0 0 . 2 3 7 . 7 6 9 1