Rtp (Multicast); Ports & Devices; Led Settings; Maintenance - Axis 210 User Manual

RTP (multicast)

Multicast must be enabled for these settings to take effect. The settings are only valid when
MPEG-4 is used as the video format. Multicast is automatically configured and should
normally not be changed. Enter the IP address and the port number to use for the video
stream in the required fields.
Only IP addresses within certain ranges can be used for multicasting. The camera has been
pre-configured with an address from these ranges, and this does not normally need to be
changed. Please contact your network administrator if you have special requirements.
Notes:
•The viewers do not need to know this IP address or port number, only the main IP address or host name
used for accessing the camera.
•Setting the video port number to 0 means a random port number will be used.
If IP packets (i.e. data) fail to be delivered to their destination within a reasonable length of
time the number entered in the Time to live field tells the network routers when to discard
the packet. The value is usually measured in 'hops', i.e. the number of network routers that
can be passed before the packet arrives at its destination or is dropped.
Ports & Devices
I/O Ports - the pinout, interface support and the control and monitoring functions
provided by this connector are described in The I/O Terminal Connector, on page 47.

LED Settings

The Status indicator LED on the front of the camera can be set to flash at a configurable
interval (or to not light up at all) whenever the unit is accessed. For a listing of all LED
behavior, see page 8, or the online help.
Note:
The LED does not flash when the stream is retrieved using MPEG-4 multicast.

Maintenance

Restart - The unit is restarted without changing any of the settings. Use this method if the
unit is not behaving as expected.
Restore - The unit is restarted and most current settings are reset to the factory default
values. The only settings saved are:
• the boot protocol (DHCP or static)
• the static IP address
• the default router
• the subnet mask
• the system time
AXIS 210/211/211A - System Options
39