Setting The Password; Accessing The Cameras From The Internet; Focusing - Axis 210 User Manual

AXIS 210/211/211A - Accessing the Camera
10

Setting the Password

1. When accessing a camera for the first time,
the 'Configure Root Password' dialog will be
displayed on the screen.
2. Enter a password and then re-enter it, to
confirm the spelling. Click OK.
3. The 'Enter Network Password' dialog will appear. Enter the User name: root
Note: The default administrator user name root is permanent and cannot be
deleted.
4. Enter the password as set in step 2 above, and click OK. If the password is lost,
the cameras must be reset to the factory default settings. See page 41.
5. If required, click Yes to install the AXIS Media Control (AMC). You will need
administrator rights on the computer to do this.

Accessing the cameras from the Internet

Once installed, a camera is accessible on your local network (LAN). To access the camera from the Internet you must
configure your broadband router to allow incoming data traffic. For security reasons this is usually done on a specific
port. Please refer to the documentation for your broadband router for further instructions.
For more information, please visit the AXIS Internet Dynamic DNS Service at www.axiscam.net or, for Technical notes
on this and other topics, visit the Axis Support Web at www.axis.com/techsup

Focusing

To focus the AXIS 210, simply turn the adjustment ring on the lens until the focus is
satisfactory.
To focus the AXIS 211/211A, follow the instructions below.
1. From the Basic Configuration page in the setup tools, open the Focus adjustment
page.
2. Set the DC-Iris to Disabled
and click Save.
3. Unscrew the zoom puller on
the lens by turning it
anti-clockwise. Adjust the
zoom as required. Re-tighten
the zoom puller.
4. Unscrew the focus puller on
the lens. Adjust the focus as
required. Re-tighten the
focus puller.
Zoom puller
(Tele/wide)
Focus puller
AXIS 211/211A