Table of Contents
Advertisement
IPPBX IP02 User Manual
Reset follow me settings by dialing *70 (default code, can be changed). After dialing in, PBX will prompt a "beep",
then the setting is completed and the call will be hung up.
NOTE: Default Follow Me settings are as below:
Always: Disabled
When no answer: Enabled
When busy: Enabled
Forward to: Voice Mail
Enable/Cancel Unconditional Call Forward
Enable/Disable call forward Always function.
Enable/Cancel Call Forward On Busy
Enable/Disable call forward When Busy function.
Enable/Cancel Call Forward On No-Answer
Enable/Disable call forward When No Answer function.
Call Forward to Number
Set the destination for call forward to number by dialing *74 (default code, can be changed), if the number is not
set yet, dial *74+number to set it.
Call Forward to Voice Mail
Set the destination for call forward to voicemail.
Enable/Cancel Do Not Disturb
~ 19 ~
ATCOM TECHNOLOGY CO., LIMITED
Advertisement
Table of Contents
Need help?
Do you have a question about the IPPBX IP02 and is the answer not in the manual?
Questions and answers