Other Basic Operations - Fujitsu Plasmavision P42HTS51E User Manual

OTHER BASIC OPERATIONS

CONVENIENT FUNCTIONS
Still Picture
DISPLAY
Picture Mode
Picture Memory
Audio In
Dual channel switching
OFF-timer
Note
• Functions may not be available with some models and some device options.
Press .
The currently viewed scene can be viewed as a still picture.
Convenient when you want to take a note, etc. Press again to return to the normal picture.
Displaying on-screen information.
Press .
The channel or mode is indicated on the screen for 5 seconds.
Press .
This button can be used to switch the picture mode.
In the picture mode, you can switch between the set status and the fine mode.
* For the picture mode settings, see "Setting Picture Mode (P. E-34)".
Press .
This button can be used to recall the settings of the picture memories 1 – 8. Each time this button is
pressed, the setting changes as follows.
* For the picture memory settings, see "Setting Picture Memory (P. E-35)".
Press .
Switches the input audio. Each time this button is pressed, the input changes as follows.
[When other than HDMI input was selected]
[For HDMI]
* Digital audio input handles PCM only.
* The digital audio input terminal on the display complies with a sampling frequency of 48 kHz.
In the case of outputs with another frequency, connect to an audio system (amplifier)*.
Press .
This function enables selection of the audio mode when there is a dual-channel broadcast. Each time this
button is pressed, the mode is switched as shown in the figure below.
Depending on the broadcast, this function may not be available.
Press .
This can be used to set the time before the power is turned off (stand-by state). Each time this button is
pressed, the setting changes as follows.
E-29