Alarm Output Connection; Pressed-Line Terminal Introduction - HIKVISION DS-2CD726F-PT series User Manual

2.3 Alarm output Connection

There are two on/off alarm inputs and one on/off alarm output. The following figure gives you visual
illustration.
The alarm output is a on/off output that requires external power supply on connection. The external
direct current supply shall not be beyond 12V DC/30mA. Use alternating-current main, please attach the
relay. Equipment damage or electric shock may cause without relay.

2.4 Pressed-Line Terminal Introduction

Connect the external alarm input, output and RS-485 control line, please gently press the orange
Pressed-Line Terminal and Plug the line into the connection hole, then release the Pressed-Line Terminal.
[Notice] Gently draw the line to make sure the line is firmly connected, which avoid the open circuit
and out of control.
©2006 – 2010 by HIKVISION. All rights reserved.
Figure 2-3-1 Alarm output Connection
Figure 2-4-1 Pressed-Line Terminal
12
Hikvision Technical Manual