Setup The Main Menu Controls - Digimerge DHT304 Installation & User Manual

SETUP THE MAIN MENU CONTROLS

Enter the MENU screen by pressing the Setup button. Scroll through the 11 options by
pressing the UP and DOWN buttons (i.e. ◄=left, ▲=up, ▼=down, or ►=right). To enter a
sub-menu, press the Enter button (i.e. QUAD/ENTER) where the highlighted scroll bar is
located. To exit the Main Menu, scroll down to the Exit option and press the Enter button.
Note: In sub-menu of the Main Menu, you can exit the Menu mode by selecting Exit, or
you can return to the Main Menu by selecting Return. The Menu is exited automatically
after 20 sec of inactivity.
1. TIME / DATE SET
displayed on the monitor, and also program the information you'd like to appear in the
On-Screen Display.
(i) DISPLAY : Selecting [Y] enables on screen display of the date & time.
Selecting [N] hides this information.
(iii) TIME : Change the time (24 hour clock)
(iv) DATE : Change the date.
(v) DATE FORMAT : There are three formats to display the date:
MM / DD / YYYY : for U.S.A.
YYYY / MM / DD : for Asian countries.
DD / MM / YYYY : for European countries.
2. SEQUENCE SET
each channel to appear on-screen before automatically switching to the next channel in
Sequence mode. The Dwell Time is 0-59 seconds selectable for each of the 4 channels
and for Quad mode.
Note: Channels without a camera, a Video Loss, or a Dwell Time of zero will be skipped
in sequencing.
3. TITLE SET
location (up to 8 characters), or remove the titles from the on-screen display.
(i) DISPLAY : Selecting [Y] will enable the camera titles to appear in the on-
screen display. Selecting [N] will remove all titles from appearing in the on-screen
display.
(ii) CH 1 - 4: Change the titles of each individual camera (Maximum 8 digits
possible).
4. ALARM SET
Alarm function by channel.
(i) ALARM: Selecting [OFF] disables PIR motion detection from triggering any
alarm.
- This sub-menu allows you to change the Time and Date
-
This sub-menu allows you to select how long you'd like
- This sub-menu allows you to change the title of each camera
- This sub-menu allows you to enable / disable the camera's PIR
23