Maintenance Count Value (Maint Cnt Value); Reset Maintenance Count Value (Reset Maint Cnt); Reset Photoconductor Maintenance Counter (Reset Pc Cnt); Print Quality - Lexmark E460dn Service Manual

Maintenance Count Value (Maint Cnt Value)

The Maintenance Count Value displays the current value of the Maintenance Kit counter which provides a rough
gauge of the printer's usage. A simplex print job increases the counter by one, and a duplex print job increases
the counter by two. Press
Press to return to the Configuration Menu.
Note: When the Maintenance Count Value is equal to the Maintenance Kit's rated life, the operator panel
displays the "80 Scheduled Maintenance" message. Perform the required maintenance, and then reset the
Maintenance Kit counter to "0."

Reset Maintenance Count Value (Reset Maint Cnt)

This setting resets the maintenance count value to "0."
1.
Press
Select Reset.
2.
Resetting Maintenance Counter displays.
3.
Once initiated, the reset operation cannot be canceled. Press

Reset Photoconductor Maintenance Counter (Reset PC Cnt)

This setting resets the photoconductor kit page counter and clears any warnings or photoconductor exhausted
messages. This operation should be performed only after a new photoconductor unit has been installed.
Print Quality Pages
This setting is a limited version of the Print Quality Pages setting that appears in the Diagnostics menu. This
setting reports the values of a broad range of printer settings and tests the printer's ability to generate
acceptable printed output. Press
the printing cannot be canceled and no buttons are active until the printing completes.
to enter this setting. The following displays:
Maintenance Count Value
to enter the Reset Maintenance Count Value setting. The following displays:
to print the report. Printing Quality Test Pages will display. Once started,
[Value]
Reset Cnt
✔Reset
or to return to the Configuration Menu.
4513-630, -63W, -6EW
3-3
Diagnostic aids