NEC N8100-1410F User Manual page 64

2-30 General Description
5.
As shown in the figure below, hold the tray with a hand and press the disc with fingers of
another hand to make the hole of the disc fit to the rotor at the center of the tray.
Press this part of disc.
6.
Push the front of the tray lightly to retract it into the drive.
IMPORTANT: If a noisy sound in driving the optical disk drive occurs
after setting a disc, set it again correctly.
To take out the disc from the optical disk drive, press the Eject button in the similar way in setting
the disc to make the tray go out.
If the access LED is lit, the disc is being accessed. Confirm that the access LED is not lit before
pressing the Eject button.
As shown in the figure below, hold the tray with a hand and take the end of the disc lightly by the
fingers of another hand with the suppression of the rotor at the center of the tray to remove the disc
from the tray.
Rotor