Table of Contents
Advertisement
8.
Select the proper SCSI Adapter and press Enter.
– [LSI MegaRAID SAS RAID Controller Driver (Server 2003 for x64)]
(When N8103-116 board is installed.)
– [LSI MegaRAID SAS RAID Controller Driver (Server 2003 for x64)]
(When N8103-117 board is installed.)
Continue performing tasks according to the subsequent messages that appear.
9.
When the following message is shown, press Enter to start "Welcome to Setup".
IMPORTANT:
the hard disk larger than 2,097,152MB (2TB), you can specify only a
value equal to or less than 2,097,152MB as partition size.
10.
When the installation of Windows Server 2003 x64 Edition has finished, the system
reboots automatically.
11.
The [Windows Setup] screen will be displayed after logged on to the system.
IMPORTANT:
In this case, the [Windows Setup] screen may not be displayed.
Be sure to install Microsoft Windows Server 2003 R2 x64 Edition
DISC 2 according to the following procedures.
You can install Microsoft Windows Server 2003 R2 x64 Edition
DISC 2 after the application of "System update".
Be sure to install Microsoft Windows Server 2003 R2 x64 Edition
DISC 2.
In this case, note that the [Windows Setup] screen is not displayed.
12.
Insert Microsoft Windows Server 2003 R2 x64 Edition DISC 2 CD-ROM into the optical
disk drive.
Confirm the parameters and click [OK].
13.
When the installation has completed, remove Microsoft Windows Server 2003 R2 x64
Edition DISC 2 CD-ROM from the optical disk drive, and restart the system.
After installation is completed, be sure to execute the tasks described in "Driver
Installation and Advanced Settings" and "Updating the System" of this chapter.
Installing Windows Server 2003 x64 Editions D-7
If you install Windows Server 2003 x64 Editions on
Advertisement
Table of Contents
Troubleshooting
