NEC N8100-1410F User Manual page 262

8-22 Troubleshooting
Fail to start the OS with the /3GB switch
→ System often fails to start the OS with the /3GB switch.
In this case, please adjust the capacity of the user mode area using the /userva
switch in reference to the following URL.
http://support.microsoft.com/kb/316739/en
During installation, the following warning is registered in the System Log of the
Event Viewer:
Error detected on the device \Device\CdRom0
during the paging operation.
→ There is no problem on this issue.
Fail to start the OS:
Is a floppy disk in the floppy disk drive?
→ Take out the floppy disk and restart the server.
Is the NEC EXPRESSBUILDER DVD in the optical disk drive?
→ Take out the NEC EXPRESSBUILDER DVD and restart the server.
Is the OS broken?
→ Use recovery process to recover the system.
The OS presents unstable operation:
Did you update the system?
→ Installing a network drive after installation of the OS may cause unstable
operation. Use the NEC EXPRESSBUILDER DVD to update the system. (See
Chapter 6.)
The system does not restart automatically when a stop error occurs, though the
system is adjusted to automatically restarting:
→ When the system does not restart automatically, restart it manually.
The system restarts automatically when a stop error occurs, though the system is
NOT adjusted to automatically restarting:
→ There is no problem about this issue.
Check the System Event Log to confirm that STOP error occurred.