NEC N8100-1056F User Manual page 337

8.
Place the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive and reboot the
server.
9.
Run "Initialize Remote Management Card".
Refer to Chapter 6 for details.
10.
Run BIOS SETUP utility and check to see that the menus related to the RMC are
displayed.
Refer to Chapter 4 for details. If no additional menus are displayed, reinstall the RMC.
11.
In the BIOS SETUP utility, select "Yes" for [Reset Configuration Data] in the [Advanced]
menu.
This setting is required to change the hardware configuration data. See Chapter 4 for
details.
12.
Reboot the server and run NEC EXPRESSBUILDER to save system information.
Refer to Chapter 3 or 6 for details.
13.
If the advanced remote management card is installed and KVM console feature is used,
update the graphics accelerator (see Chapter 5).
NOTE:
Refer to the manual that comes with an optional advanced
remote management card for the monitor resolution.
14.
Override installation of NEC ESMPRO Agent if installed.
To correct the system information and event log from the management PC, NEC
ESMPRO Agent must be installed in the server.
Upgrading Your Server 9-51