NEC N8100-1056F User Manual page 268

8-20 Troubleshooting
The system restarts automatically when a stop error occurs, though the system is NOT
adjusted to automatically restarting.
→ There is no problem about this issue.
Check the System Event Log to confirm that STOP error occurred.
Cannot turn the power OFF at the blue screen:
→ If you want to turn off the power at the blue screen, execute forced shutdown
(forced shutdown: continue to press POWER switch for 4 seconds). The power
will not be turned off if you press the switch for less than 3 seconds.
The event log after every logon to Windows 2000 includes the following error log:
Description (D)
The CPUs in this multiprocessor system are not all the same revision level.
To use all processors the operating system restricts itself to the features of
the least capable processor in the system. Should problems occur with
this system, contact the CPU manufacture to see if this mix of processors
is supported.
Has the CPU been expanded?
→ If the different revision (stepping) of the processor is installed in the
multiprocessor system, Windows 2000 logs the above information every startup.
If this message is logged, it is no problem for operation.
The OS presents unstable operation:
Did you update the system?
→ Installing a network drive after installation of the OS may cause unstable
operation. Use the NEC EXPRESSBUILDER CD-ROM to update the system.
(See Chapter 6.)
When any trouble occurred, the system does not run according to the specification of "Restart
automatically":
→ When any trouble occurred on Windows 2000, the system may not restart
automatically even if "Restart automatically" is specified. In such case, restart
the system manually.
Cannot turn the power OFF at the blue screen:
→ If you want to turn off the power at the blue screen, execute forced power off
(forced shut down: continue to press POWER switch for 4 seconds). The power
will not be turned off if you press the switch just one time.