Uconnect® Voice Command - Jeep Wrangler 2013 User Manual

• Any voice commanded system should be used only in safe driving conditions
following applicable laws regarding phone use. Your attention should be
focused on the safely operating the vehicle. Failure to do so may result in a
collision causing you and others to be severely injured or killed.
• In an emergency, to use Uconnect
• turned on,
• paired to Uconnect
• and have network coverage.
Uconnect® VOICE COMMAND
Voice Command Operation
• The Uconnect ® Voice Command system allows you to control your AM, FM radio,
satellite radio, disc player, HDD, Uconnect
supported portable media devices.
• When you press the "Voice Command" button
faceplate or steering wheel, you will hear a beep. The beep is your signal to give a
command. If you do not say a command within a few seconds, the system will
present you with a list of options. If you ever wish to interrupt the system while it
lists options, press the "Voice Command" button
say your command.
NOTE:
Visit http://www.driveuconnect.com/features/voiceCommand/ for more info on which
voice command features apply to your vehicle
• Start a dialogue by pressing the "Voice Command" button
a beep. The beep is your signal to give a command. Below are a list of voice
commands for each of the different modes.
WARNING!
® Phone, your mobile phone must be:
® Phone,
ELECTRONICS
Phone, a memo recorder, and
®
located on the radio
, listen for the BEEP, and
, you will hear
79