Jeep Wrangler 2013 User Manual page 79

• Press the "Phone"
• Wait for the "ready" prompt and BEEP.
• (After the BEEP), say "setup" or "Uconnect device setup".
• (After the BEEP), say "device pairing".
• (After the BEEP), say "pair a device".
• Follow the audible prompts.
• You will be asked to say a four-digit
Personal Identification Number (PIN),
which you will later need to enter into
your mobile phone. You can say any
four-digit PIN. You will not need to
remember this PIN after the initial pair-
ing process.
• You will then be prompted to give the phone pairing a name (each phone paired
should have a unique name).
• Next you will be asked to give this new pairing a priority of 1 thru 7 (up to seven
phones may be paired); 1 is the highest and 7 is the lowest priority. The system will
only connect to the highest priority phone that exists within the proximity of the
vehicle.
• You will then need to start the pairing procedure on your cell phone. Follow the
Bluetooth ® instructions in your cell phone Owner's Manual to complete the phone
pairing setup.
Phonebook
Phonebook Download – Automatic Phonebook Transfer From Mobile Phone
If equipped and specifically supported by your phone, Uconnect
downloads names (text names) and number entries from your mobile phone's phone-
book. Specific Bluetooth
feature. Automatic Transfer is indicated by a green arrow at the bottom of the screen.
See www.UconnectPhone.com for supported phones.
• Automatic download and update, if
supported, begins as soon as the
Bluetooth ® wireless phone connection
is made to the Uconnect
example, after you start the vehicle.
button to begin.
® Phones with Phone Book Access Profile may support this
® Phone, for
ELECTRONICS
Phone automatically
®
77