Table of Contents
Advertisement
Image 3-12
Center pins must match center holes
No electrical connections have to be made while installing the lamp casing. All connections are automatically
made while inserting the lamp casing.
While starting up the projector, the electronics detect if a lamp is installed. If no lamp is installed, it is not
possible to start up the projector.
3.6 Transporting the projector
What to do?
1. Switch the projector to stand by.
2. Let cool down the projector for at least 15 minutes.
3. Switch off the projector and unplug from the wall outlet.
4. On the input side of the projector, remove the side by turning the 3 bolts a quarter turn counter clockwise.image 3-8
5. Flip the lower side of the plate a little and pull then downward to remove the plate.
6. Turn the retaining bolts of the lamp a quarter counter clockwise.image 3-12
7. Pull out the lamp casing. Wear heat resistant gloves, the case can be hot.
8. Pack the lamp casing into the lamp flightcase and transport it verticaly.
3.7 Re-adjusting the lamp position in the lamp casing
As the projector has to be opened, this procedure has to be performed by qualified service technician.
Why
With higher run times, the light output of the lamp will decrease, which results in a lower light output on the screen. This light output
decrease can be compensated by readjusting the position of the lamp.
How to readjust.
1. On the side of the inputs, turn the 3 retaining bolts a quarter counter clockwise.
2. Flip the lower side a little backwards and take off the side cover.
3. Start up the adjustment mode and select Service.
4. Select Lamp. The Z-axis indication (lamp menu in service mode) will be helpful while turning screw B . (image 3-13)
5. Loosen the nut A (image 3-13)on the back of the lamp casing (nutdriver 10).
R5976333 BARCOELM R18 17092002
3. Installation Guidelines
17
Advertisement
Table of Contents
