Stand Assembling; Feets; Bar; Stand Assembly Screws (M4 × 10 Mm) - Pioneer PDP-60MXE20 Technical Manual

Table Top Stand: PDK-TS26

4.4.4 Stand assembling

1 Remove the cardboard and accessories (screws,
operating instructions) from the box.
¶ View of packaged items
Shock
absorbing boxes
2 Remove the bar then remove the shock absorbing
boxes from the left and right sides.
3 Remove the two boxes containing the feet, and set
them upside down on the floor.
68
4 Tear off the protective sheets covering the feet from
Cardboard
Shock absorbing
boxes
Screws / Securing
brackets
Operating instructions

Bar

(Covered with
protective sheets)
Feet
(Covered with protective sheets)
5 Take the protective sheet off the bar that you removed
6 Pick up the boxes containing the feet, turn them over
their perforated lines so you can see their attach-
ments.
¶
Place them so the attachments are towards you.
Attachment
Perforated line
in step 2, insert the bar aligned with the guide pins of
the feet.
If the bar and guide pins on the feet do not match,
the feet and bar are in reversed position. Reverse
the left and right ends of the bar and align it with the
pins again.
Then tighten it with the included stand assembly
screws (M4 × 10 mm).
Guide pins
Caution
Tighten the screws firmly. The stand may fall over
causing injuries.
again, and put them back on the floor. Then take the
box out of its stand.
Toward you