Color Decoding Setting - Pioneer PDP-60MXE20 Technical Manual

Menu Mode

7) Color Decoding Setting

When a video signal is input at INPUT1, INPUT2 and INPUT5, it corresponds to an RGB and component video signal.
This setting must comply with the connected device.
The setting should be performed as shown below for INPUT1, INPUT2, and INPUT5.
(Example)
• When reproducing an RGB signal:
• For reproduction from a DVD player: Set to 'COLOR DECODING: COMPONENT1'.
Settable condition:
Factory setting:
1 Select 'SETUP'.
2 Place the cursor over 'COLOR DECODING' then press
the [SET] button to change the setting.
Each time the [SET] button is pressed, the setting changes
as shown below.
3 RGB
COMPONENT22
Set 'COLOR DECODING' as follows.
Please take care when assigning settings. Incorrect
settings can adversely affect the Plasma Display.
Connected
component
Component video output of
Y/Cb/Cr format.
For example, DVD player, etc.
Component video output of
Y/Pb/Pr format.
For example, digital tuner, etc.
RGB video output of a video deck
etc., with RGB output
DVI video output of an AV
component with DVI output port
RGB video output of a PC
106
Set to 'COLOR DECODING: RGB'.
INPUT1, INPUT2, INPUT5
When a video signal (signal other than a PC signal) is input
For 525i, 525p, 625i, 625p signal input: COMPONENT1
For 750p, 1125i, 1125p, 1250p signal input: COMPONENT2
3 COMPONENT1
SETUP
COLOR DECODING
COMP.1
COMP.2
RGB
RGB
Not supported
Screen 2
M E N U
P I C T U R E S C R E E N
C O L O R T E M P.
A U T O P O W E R O F F
D N R
M P E G N R
C T I
P U R E C I N E M A
C O L O R D E C O D I N G
C O L O R S Y S T E M
S I G N A L F O R M AT
SET CHANGE
I N P U T 1
S E T U P O P T I O N
: M I D D L E
: D I S A B L E
: M I D D L E
: L O W
: O N
: O F F
: R G B
: A U T O
MENU EXIT