Checking For Open Zones - ADEMCO Vista-50P User Manual

CHECKING FOR OPEN ZONES

Before arming your system, all protected doors, windows and
Using the Q
other protection zones must be closed or bypassed (see
READY Key
BYPASSING section). Otherwise the keypad will display a "Not
Ready" message. Using the READY key will display all zones
that are faulted, making it easier for you to secure any open
zones.
To show faulted zones:
1. Do not enter security code, but simply press
2.
DISARMED -
PRESS
T TO SHOW
FAULTS
FAULT 05 FRONT
UPSTAIRS
BEDROOM
DISARMED
READY TO ARM
Ð 20 Ð
Note: Some keypads light a green LED
when the system is ready. If not lit, the
system is not ready to be armed.
Typical fault display
Secure or bypass the zones displayed
before arming the system. The "Ready"
message will be displayed
protection zones have been either closed
or bypassed.
NOTE: All or part of this message may be
replaced by a customized message
programmed by the installer. Bear this in mind
whenever the instructions indicate that the
"DISARMED" or "READY" message will be
displayed.
READY
ÊQÊ .
when all