Table of Contents
Advertisement
OWNER'S MANUAL & OPERATING INSTRUCTIONS
9000 Starting Watts / 7200 Rated Watts
Electric start
PORTABLE GENERATOR
MODEL NUMBER
41552
10006 Santa Fe Springs Road
SAVE THESE INSTRUCTIONS
Santa Fe Springs CA 90670
Important Safety Instructions
USA / 1-877-338-0999
MADE IN CHINA
are included in this manual.
REV 41552-20130323
www.championpowerequipment.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Champion Power Equipment 41552
Summary of Contents for Champion Power Equipment 41552
-
Page 1: Electric Start
9000 Starting Watts / 7200 Rated Watts Electric start PORTABLE GENERATOR MODEL NUMBER 41552 10006 Santa Fe Springs Road SAVE THESE INSTRUCTIONS Santa Fe Springs CA 90670 Important Safety Instructions USA / 1-877-338-0999 MADE IN CHINA are included in this manual. REV 41552-20130323 www.championpowerequipment.com... - Page 2 AN IMPORTANT MESSAGE ABOUT TEMPERATURE: Your Champion Power Equipment product is designed and rated for continuous operation at ambient temperatures up to 40°C (104°F). When your product is needed your product may be operated at temperatures ranging from -15°C (5°F) to 50°C (122°F) for short periods.
-
Page 3: Table Of Contents
41552 9000 Starting Watts / 7200 Rated Watts Electric Start PORTABLE GENERATOR TABLE Of CONTENTS Maintenance Schedule ....Introduction ...... -
Page 4: Introduction
Introduction Accessories Congratulations on your purchase of a Champion Champion Power Equipment manufactures and sells Power Equipment generator. CPE designs and builds accessories designed to help you get the most from your generators to strict specifications. With proper use and purchase. -
Page 5: Manual Conventions
Please call our help line at 1-877-338-0999 situation which, if not avoided, could result in death or serious injury. CAUTION CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. REV 41552-20130323... -
Page 6: Safety Rules
Inform your electricity provider immediately if you or anyone in your household depends on electrical equipment to live. Inform your electrical provider immediately if a loss of power would cause you or anyone in your household to experience a medical emergency. REV 41552-20130323... - Page 7 – Electrical output is lost – Equipment sparks, smokes or emits flames A spark arrestor may be required. The operator – Equipment vibrates excessively should contact local fire agencies for laws or regulations relating to fire prevention requirements. REV 41552-20130323...
-
Page 8: Controls And Features
Battery – Used to start the engine. Air Cleaner – Protects the engine by filtering dust and debris from the intake air. Power Panel – See “Power Panel”. Recoil Starter – Used to start the engine. REV 41552-20130323... -
Page 9: Power Panel
120/240V, 30A Twist-Lock Receptacle Circuit Breakers – Protects the generator against (NEMA L14-30R) – May be used to supply electrical overload. electrical power for the operation of 120 and/or 240 Volt AC, 30 Amp, single phase 60 Hz electrical loads. REV 41552-20130323... -
Page 10: Parts Included
41552 ENGLISH CONTROLS AND fEATURES Parts Included Your 41552 Gasoline Powered Generator ships with the following parts: Wheel Kit – 10 in. Wheel ...... -
Page 11: Assembly
2. Slide the wheel bolt (M10x120) through the washer, sleeve and wheel. 3. Slide the bolt through the mount point on the frame. 4. Fasten securely with the M10 nut. 5. Repeat steps 2-4 to attach the second wheel. REV 41552-20130323... -
Page 12: Add Engine Oil
3. Add up to 1.16 qt (1.1 L) of oil and replace oil fill bearing that requires no additional lubrication for cap/dipstick. DO NOT OVERFILL. the life of the bearing. 4. Check engine oil level daily and add as needed. REV 41552-20130323... -
Page 13: Add Fuel
DO NOT light cigarettes or smoke when filling the electrician to ensure compliance with local electrical codes. fuel tank. WARNING Pouring fuel too fast through the fuel screen may result in blow back of fuel at the operator while filling. REV 41552-20130323... -
Page 14: Operation
During operation the muffler and exhaust fumes produced will become hot. If adequate cooling and breathing space are not supplied, or if the generator is blocked or contained, temperatures can become extremely heated and may lead to fire. REV 41552-20130323... -
Page 15: Connecting Electrical Loads
If the generator will be connected to a building electrical system, consult your local utility company or a qualified electrician. Connections must isolate generator power from utility power and must comply with all applicable laws and codes. REV 41552-20130323... -
Page 16: Do Not Overload Generator
4. Allow the engine to stabilize. 5. Plug in and turn on the next item. 6. Allow the engine to stabilize. 7. Repeat steps 5-6 for each additional item. NOTE Never exceed the specified capacity when adding loads to the generator. REV 41552-20130323... -
Page 17: Maintenance And Storage
4. Saturate in clean engine oil. cap/dipstick. DO NOT OVERFILL. 5. Squeeze in a clean, absorbent cloth to remove all excess oil. 6. Place the filter in the assembly. 7. Reattach the air filter cover and snap in place. REV 41552-20130323... -
Page 18: Spark Arrester
Contact our help line at 1-877-338-0999 to locate the 3. Remove the spark arrester screen. nearest Champion Power Equipment certified service 4. Carefully remove the carbon deposits from the spark dealer for your generator or engine maintenance needs. arrester screen with a wire brush. -
Page 19: Storage
3. Repeat steps 1-2 for the red/positive battery lead. and the Fuel Valve are switched to the the 4. Store the battery in a cool, dry place. OFF position and the battery leads have been disconnected from the battery. REV 41552-20130323... -
Page 20: Specifications
....6.5 gallons (25 L) Your Champion Power Equipment product is designed – Gross Weight ... . -
Page 21: Wiring Diagram
41552 ENGLISH SPECIfICATIONS Wiring Diagram REV 41552-20130323... -
Page 22: Parts Diagram
41552 ENGLISH SPECIfICATIONS Parts Diagram REV 41552-20130323... -
Page 23: Parts List
Rectifier 5.1900.029 Grounding Line Bolt And Washer Assembly 1.5789.0612 Flange Bolt M6×12 1.9074.1.0538.2 M5×38 1.862.06 Lock Washer Ø6 152.210003.04 Plug 152.201200.00 Motor Mount 152.210002.12 Control Box 1.96.08 Washer Ø8 1.5789.0835 Flange Bolt M8×35 1.894.1.10 Circlip Ø10 152.200703.04.2 Pin,Handle REV 41552-20130323... -
Page 24: Engine Parts Diagram
41552 ENGLISH SPECIfICATIONS Engine Parts Diagram REV 41552-20130323... -
Page 25: Engine Parts List
45.110007.00 Spring, Governor 47.010100.01 Cylinder Head 46.080300.20 Air Guide, Upper 2.01.006 Stud.Bolt (M8×34) 47.131017.21 Standard Main Jet 2.15.002 (F6RTC) Spark Plug (F6RTC) 46.091000.04 Air Cleaner Assembly 2.08.014 Flange Bolt M10×80 46.061000.00 Recoil Assembly 46.020002.00 Gasket, Cylinder Head Cover REV 41552-20130323... -
Page 26: Troubleshooting
Review load and adjust. See “Power Management” Faulty cords or device Check for damaged, bare or frayed wires. Replace defective device for further technical support: Technical Service Mon – Fri 8:30 AM – 5:00 PM (PST/PDT) Toll Free: 1-877-338-0999 tech@championpowerequipment.com REV 41552-20130323... -
Page 27: Warranty
Warranty Qualifications Other Exclusions Champion Power Equipment (CPE) will register this This warranty excludes: warranty upon receipt of your Warranty Registration Card – Cosmetic defects such as paint, decals, etc. - Page 28 Champion Power Equipment, Inc (CPE), Emission Control System Warranty Your Champion Power Equipment (CPE) engine complies with Environment Canada (EC) emission regulations. YOUR WARRANTY RIGHTS AND OBLIGATIONS: CPE is pleased to explain the Emission Control Systems Warranty on your 2013 small off-road engine.
- Page 29 EMISSION CONTROL SYSTEM WARRANTY The following are specific provisions relative to your Emission Control System Warranty Coverage. Emission Control System Warranty (ECS Warranty): 1. APPLICABILITY: The ECS Warranty Period shall begin on the date the new engine or equipment is delivered to its original, end-use purchaser, and shall continue for 24 consecutive months thereafter.
- Page 30 Champion Power Equipment dealer who is authorized by Champion Power Equipment, Inc. to sell and service that CPE product during his normal business hours. Claims for repair or adjustment found to be caused solely by defects in material or workmanship will not be denied because the engine was not properly maintained and used.
Need help?
Do you have a question about the 41552 and is the answer not in the manual?
Questions and answers