Basic Controls; Non-Through & Through Cuts - Grizzly G0690 Owner's Manual

Basic Controls

ON/OFF Switch: starts and stops the motor.
Safety pin & Chain: When installed (Figure 40),
disables the switch to prevent accidental startup.
Figure 40. oN/oFF switch disabled.
Blade Tilt: to adjust the blade tilt, loosen the
blade tilt lock, turn the blade tilt handwheel to
position the blade at the desired angle, then
tighten the lock shown in Figure 41.
Blade height
Blade tilt
lock
lock
Blade height
handwheel
Figure 41. Basic table saw controls.
Blade height: to set the blade height, unlock the
blade height lock, turn the handwheel to set the
blade height approximately
workpiece, then re-tighten the blade height lock.
Fence Lock: after adjusting the fence to the
desired width of cut, lock it in place by firmly push-
ing the fence lock down until it stops.
Model g0690/g0691 (Mfg. 11/10+)
safety
safety
pin
pin
oN
switch
Fence lock
Blade tilt
handwheel
⁄ " higher than the
1
4
Non-Through &
Through Cuts
Non-Through Cuts
Figure 42. Example of a non-through cut.
"
Through Cuts
Figure
Figure 43. Example of a through cut (blade
guard not shown for illustrative clarity).
Figure
-33-