Grizzly G0690 Owner's Manual page 26

5.
insert the lip of the lower part of the dust port
into the cabinet and tighten the thumb knob
(already installed) to secure (see Figure
15).
thumb Knob
Figure 15. dust port installed.
6.
remove the M8-1.25 x 30 cap screws, and
8mm flat washers and lock washers from the
ends of the main table.
7.
inspect the extension wings and main table
mating surfaces for burrs or foreign materials
that may inhibit assembly.
the mating edges of the wings and the table
must be clean, smooth, and flat. use a wire
brush or file if necessary to clean up the
edges. this step will ensure that the wings
mount properly to the main table.
8.
While a helper holds the wings in place,
attach each extension wing to the main table
with the four M8-1.25 x 30 cap screws, 8mm
lock washers and 8mm flat washers removed
in Step 6 (Figure 16).
x4
Figure 16. Extension wings installed.
-24-
9.
place the straightedge across the extension
wings and main table to make sure that the
combined table surface is flat.
— if the combined table surface is flat, skip to
the next step.
— if the outside end of the extension wing tilts
down, use a strip of masking tape along the
bottom edge of the main table to shim the
extension wing up (Figure 17).
Figure 17. Masking tape location for tilting the
extension wing up.
— if the outside end of the extension wing
tilts up, use a strip of masking tape along
the top edge of the main table to shim the
extension wing down (Figure 18).
Note: After reinstalling wings, remove all
excess masking tape with a razor blade.
Figure 18. Masking tape location for adjusting
the extension wing down.
Model g0690/g0691 (Mfg. 11/10+)