Nokia A032 Getting Started Manual page 39

In its factory default
state the unit does not
have an IP address, so
it needs to be taught
one. This must be an IP
address which is not in
use by another station
on the LAN.
32
4 From any station on the wired LAN, start an
MS-DOS window and enter the following
command:
ping xxx.xxx.xxx.xxx
where xxx.xxx.xxx.xxx is the IP address you
want to assign to the Access Point.
On the fourth ping you should see that the
chasing pattern stops and that the Access
Point responds to the ping.
The Access Point will 'learn' the address to
which you issued the ping command.
5 Restart the Access Point in normal mode.
You can now configure the unit using the
normal Web based configuration utility (see
Using the Web manager in the Advanced User
Guide).
Nokia A032 Getting Started